Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Carbide blade scraper - turning a burr?

Posts

Carbide blade scraper - turning a burr?

#1

Carbide blade scraper - turning a burr?

Dave (Arlington, VA)

>Hi All -

We have a smallish family room the oak wood floor of which the previous owner previous owner appears to have pickled. We would like to refinish it ourselves. I have been looking at the ball joint scrapers from LV. I notice that there are two types of blades: a high carbon steel blade and a carbide blade. The LV website seems to recommend the carbide blade for the kind of application I have in mind.

I know how to turn a burr on my card scrapers. Can you do the same with a carbide blade? Would my burnishers stand up to the hardness of the carbide blade? Or is a carbide blade a essentially a use and replace blade.

Any insights anyone might have would be much appreciated. Thanks.

Regards -

Dave

Re: Carbide blade scraper - turning a burr?

#2

Re: Carbide blade scraper - turning a burr?

Bill Tindall, E.TN

>Check the Articles section for my Article on floor scraping. Properly sharpened a floor scraper rolls of shavings like a hand plane.

Carbide is not malleable so there will be no burr turning. It takes silicon carbide or diamond to sharpen carbide.

Re: Carbide blade scraper - turning a burr?

#3

Re: Carbide blade scraper - turning a burr?

Dave (Arlington, VA)

>Thanks, Bill. I've printed out the article and will read it.

I appreciate your help.

Regards -

Dave