Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Re-use of worn plane irons

Posts

Re-use of worn plane irons

#1

Re-use of worn plane irons

Jay Samuels

>NOT due to any design failure, I need to slit off about 3 feet of molding that I put up that protrudes about 3/8" past where is should. I figured that the easiest way to do this would be to create a custom slitter to ride along the adjacent board, which would need a good-sized single bevel blade, like a marking knife. I took an old Stanley 2" plane iron that had been sharpened about down to the slot, cut off half at a 45 degree angle with a rotary tool, and proceeded to grind a single bevel on each edge. I had always thought that the top parts of the plane irons were some lesser quality of steel, but based on the spark pattern and the effort necessary to grind the bevels, this seems like nice high carbon steel. It took a nice edge. I don't know that edge-holding should be much of an issue for a slitter. Now I just need to complete the body. Has anyone else recycled the tops of plane irons for custom applications? If so, having tried this, I would be interested to hear.

Re: Re-use of worn plane irons

#2

Yup

Bruce, a MN Galoot

>I made a couple darn good marking knives. There are a couple used up blades in my drawer that will become something else, too, but that use hasn't become apparent yet.

bruce

Re: Re-use of worn plane irons

#3

This is good to hear

Bill Houghton, Sebastopol, CA

>Some time I need to make a newiron for my No. 64 spokeshave, from the tail end of a block plane iron; I'd wondered whether I was likely to encounter soft metal in doing that. Nice to know you didn't.

Re: Re-use of worn plane irons

#4

Re: Re-use of worn plane irons

Derek Cohen (in Perth, Australia)

>Has anyone else recycled the tops of plane irons for custom applications? If so, having tried this, I would be interested to hear.

Hi Jay

I have used Stanley blades to make a bunch of knives.

Here is a set of chip carvers I built for a galootaclaus present a few years ago ...


And recently I made my brother a letter opener for his birthday (you can see the Stanley hole here incorporated into the design) ..


Regards from Perth

Derek