Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

chair leg amputation revisited

Posts

chair leg amputation revisited

#1

chair leg amputation revisited

Edward in Vancouver

>A few weeks back I asked for some help in finding a way to chop down some chairs. I got some great advice, and I am happy to report that the operation was a complete success.

The chairs in question were "bar chairs", identical to the regualr dining chairs we have in our Cafe, other than they are about 12" higher.

What I ended up doing was to make a little table 11 3/4" high. I knew I had to chop off 12", but I also knew if I goofed, I'd suffer from the hot tongue and cold shoulder synrome for quite a while. Set the chairs on my workbench and moved the little table up to the legs and resting a marking knife on the little table top I marked off all around the legs. Then I sawed. Didn't do too badly, only one chair rocked a bit--about 1/16" on one leg. From the leg offcuts I traced the leg shape on a piece of 1/4" ply and cut out the shape. Then I slipped this piece under the leg, shimmed up the chair and traced around each leg. Sawed off again. Not too bad. Did this with the other chairs so they were all the same hight. None of the chairs rocked at all. Chamfered the cut edges and stuck on felt pads.

Now I've got 12 pcs of about 11/2 x 1/1/2 solid beech around 113/4" long. They went into my "maybe someday" milk crate where they'd make good candidates to turn for tool handles.....

Re: chair leg amputation revisited

#2

Glad to hear

Bill Houghton, Sebastopol, CA

>these projects always seem so huge at first.

I'm mystified, though: if I could put all my "maybe someday" wood and bits in one milk crate, it would be big enough for milk for every trooper in Afghanistan, with leftovers to treat most of the sub-teen Afghani population. Do you just have more self-control than I do (highly probable), or do your somedays occur more frequently?

Re: chair leg amputation revisited

#3

Re: chair leg amputation revisited

Hank Knight

>Congrats! It's hard to saw while you're holding your breath, isn't it? Glad it worked out well.

Re: chair leg amputation revisited

#4

Re: chair leg amputation revisited

Bill Houghton, Sebastopol, CA

>"It's hard to saw while you're holding your breath, isn't it?"

The trick, as my father never tired of pointing out, is that you have to hold your mouth right. Having the tip of your tongue sticking out one side of the mouth helps sometimes.