Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Domestic, Figured & Live Edge Hardwoods in Stock. Best Prices for Serious Woodworkers.

question on "antique" hardware installation

Posts

question on "antique" hardware installation

#1

question on "antique" hardware installation

Bill Tindall, E.TN

>I have never installed hardware with these spreader pins before. Any secret to installation, especially getting the handle tight against the trunk so it isn't loose after installation?


img

Re: question on "antique" hardware installation

#2

Re: question on "antique" hardware installation

Chuck Nickerson

>My guess (please note this is a guess) is good instructions for using clinch nails would be helpful. Tremont Nails still sells them, Chris Schwartz has written about them, and I suspect Stephen Sheperd has something to offer on this topic.

Re: question on "antique" hardware installation

#3

Re: question on "antique" hardware installation

Stephen Shepherd in the State of Deseret

>Bill,

The cotter pin shaped snipe is put through a slot, some use a hole, but that can allow water in the chest/cabinet. They are then bent or clinched over to hold them in place.

I always bend a bit of the end of the snipe over to form a point that will engage the wood like a staple when the snipe is clinched over. You can also use nippers to put a bit of a barb on the snipe to further enhance its hold when it is driven into the wood.

Stephen

Re: question on "antique" hardware installation

#4

Re: question on "antique" hardware installation *LINK*

Wiley Horne--So. Calif.

>Bill,

Attached is a drawing by Horton Brasses that illustrates their recommended method. They show clinching like Stephen recommends.

Wiley


Horton Brasses on cotter pin fitting