Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Stanley 80 Scraper Blade

Posts

Stanley 80 Scraper Blade

#1

Stanley 80 Scraper Blade

Wayne

>what would make a good blade for this scraper picked it up for 2 bucks but didn't have a blade. Maybe a drywall knife blue steel blade??

Re: Stanley 80 Scraper Blade

#2

Re: Stanley 80 Scraper Blade

L. Hanson

>The replacement blade for the Veritas Cabinet Scraper from Lee Valley is something like $5 (plus S&H) and fits. Works very well in one of my old #80's.

Leif

www.norsewoodsmith.com

Re: Stanley 80 Scraper Blade

#3

Re: Stanley 80 Scraper Blade

Wayne Carson

>thanks I enjoy your site and have made 4 dovetail saws and some plane floats.

Re: Stanley 80 Scraper Blade

#4

A old saw blade works well. I put a...

Scott Burr in Ben Lomond, CA

>Hock iron in mine, works great.

Re: Stanley 80 Scraper Blade

#5

Re: Stanley 80 Scraper Blade

RJ Whelan

>Wayne ... the #80 is a very useful scraper, but using a thin blade/iron will turn you off pretty quickly - if you don't induce a pretty healthy bend with the thumbscrew the blade/iron will "chatter" and give you a nice little washboard on the surface you're trying to get smooth.

I used to use .125 tool steel in my #80, until I bought a couple of irons from Ron Hock. I put a 50 degree bevel on both ends (this gives me four prepped edges and will get me through all but the largest table tops). I also made a little cover for the end sticking up, as the edge can bite if you aren't paying attention - DAMHIKT.

RJ