Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Slightly OT - Safety issue in current FWW

Posts

Slightly OT - Safety issue in current FWW

#1

Slightly OT - Safety issue in current FWW

Bill Houghton, Sebastopol, CA

>The current Fine Woodworking has an article on miter gauges (P. 28ff, by Steve Latta). The first page of the article has a picture showing how to peen the miter gauge bar by hitting a ball peen hammer with a claw hammer.

I was always taught that you never hit a hammer with a hammer, since the hardened faces can chip. Were my teachers wrong?

Re: Slightly OT - Safety issue in current FWW

#2

Re: Slightly OT - Safety issue in current FWW

CJ

>To the extent that metal striking metal always gives rise to the possibility that a chip may be struck off, yes. Hammer heads are hard to avoid damage, but they are also tough. I would imagine that the likelihood of chipping in the pictured situation is fairly low. That said, why wouldn't one simply use a punch?

CJ

Re: Slightly OT - Safety issue in current FWW

#3

I find myself *LINK*

Bill Houghton, Sebastopol, CA

>sending FWW a safety-related e-mail with almost every issue these days...don't know if they're becoming sloppier or if my oncoming curmudgeonliness is getting too strong.

I'm not alone, by the way - link below recommends against it too.


http://www.hammernet.com/safety.htm

Re: Slightly OT - Safety issue in current FWW

#4

Re: I find myself

Stuart Hough

>I was taught that striking a claw hammer on any hardened tool could possibly cause the claw fingers to snap off, causing them to possibly hit you with enough force to leave an injury. Several years later I found out that "possibly" ended up being "probably", depending how much force you use. Let it suffice to be said that I NARROWLY escaped a serious eye injury. As a previous poster said, a punch would be a much more intelligient choice!

Re: Slightly OT - Safety issue in current FWW

#5

Re: Slightly OT - Safety issue in current FWW

ThomD

>It can probably be done safely if the energy isn't all that much, or someone buys a really soft ball peen hammer. And then today people wear safety glasses. It is supposed to be done with a punch which would seem like a more comon carpenter's tool than a ball peen hammer. I guess the BPH is more likely to leave a shallow dimple.

Re: Slightly OT - Safety issue in current FWW

#6

Your teachers were right. Don't hit 2 hammers.

Andrew F in Australia

>

Re: Slightly OT - Safety issue in current FWW

#7

Re: Slightly OT - Safety issue in current FWW

Todd Hughes

>The TV show myth busters did a show a while back on this and try as they would hitting various hmmers together they couldn't get them to do anything. I think they finaly hardened one really hard and brittle and broke the top off when it was hit. I believe they considered it a "Myth Busted"

Blacksmithing I have had hammers chip and then fly off, had one go into my leg once and is probably still there. Had a piece fly off a wood splitting wedge years ago and hit me.

I don't really know what you are talking about peining using two hammers like this as I didn't see the article but I have always just peined rivets using a single ball pein or straight pein hammer....Todd