Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Clip for Clipboard - ideas?

Posts

Clip for Clipboard - ideas?

#1

Clip for Clipboard - ideas?

Derek Cohen (in Perth, Australia)

>I want to make a few wooden clipboards. I don't want to use a steel paper clip (holder) if I can help it, and would prefer something in wood, so that the entire construction is wood.

Ideas?

What suggestions do you have for a wooden "clip"?

Regards from Perth

Derek

Re: Clip for Clipboard - ideas?

#2

Re: Clip for Clipboard - ideas?

Stephen Shepherd in the State of Deseret

>Derek,

I have seen two slightly different wooden 'clips' for holding a sheet of paper or two. I don't think either can hold a lot of sheets.

They are wooden L shaped pieces that are attached inverted to the board on the short arm of the L. On the underside in a recess are either a wooden ball or a wooden roller in an elongated slot.

When the paper is inserted the ball or roller moves about in the elongated slot and with the help of gravity and geometry the ball or roller holds the paper in a cam action.

I don't know if that description helps.

Stephen

Re: Clip for Clipboard - ideas?

#3

Spring

Wiley Horne--So. Calif.

>Hi Derek,

Just noodling around on something.....Suppose you had a crotch section, where a branch emerges from the trunk. So you have an acute-angle L, the trunk section forming the short arm of the L, and the branch section making the long arm of the L. The trunk section is tenoned through the base of the clipboard and made tight with a wedge inserted from the underside. The branch section comes to rest on the clipboard surface, and papers can be inserted under it. Because it is a crotch section, the branch will not break off the trunk section when lifted up (In theory!). If you wanted to make it fancy, carve the piece to include an upward extension of the trunk section, so you could push on it with your thumb, which would raise the branch arm off the clipboard surface, the easier to insert your papers.

There are other articulated 'springs' that could be made, but if this worked, the spring action would be integral to the way the fibers are arranged where the limb joins the trunk.

Wiley

Re: Clip for Clipboard - ideas?

#4

Jim in Burlington Ont.

Steam bent clip

Jim in Burlington On

>I would steam bend a few styles of clips. Limb stock may work the best.

Re: Clip for Clipboard - ideas?

#5

Bamboo

Marv....... Northern California Lake Co.

>

Re: Clip for Clipboard - ideas?

#6

Re: Clip for Clipboard - ideas?

Andy Lincoln,in Dearborn MI

>Derek,

Not quite in the criteria you gave but what about rare earth magnets

installed in both the mainboard and in the wooden clip?with the paper sandwiched in between?

Andy