Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Disston squares

Posts

Disston squares

#1

Disston squares

Bill Houghton, Sebastopol, CA

>On the way back from the dump Saturday, I picked one of three possible garage sales (no time for all three) and lucked out, a little. The picture below is of the two Disston squares I picked up, $3 for both. I can't photograph the etch, but, as best I can tell (it's pretty faint), it reads, "Henry Disston & Sons (arched across the top of the etch), Philad'a U.S.A. (in a line across the foot of the arch), No. 1 (below the city line)". They have inch and fractional markings, 6" from the inside edge of the stock to the end of the beam.

Are these at all collectible, or have I just picked up another couple of pretties? I've been intrigued to learn in recent years how many tools Disston made, or at least branded, besides saws. I now have a Disston level, marking gauge, and these two squares. The first two are not of the highest quality, but the squares are nice little tools.

Digressing: I've read that the brass binding signaled which face of the stock was square with the beam. Almost all the try squares I've seen have been bound on the inside edge only, meaning they can be used to strike a line across the stock or to test an outside corner. What did the traditional artisans use to test inside corners - or did they not test them, just fitting the drawer/door to the corner as it stood?

Also acquired: a pristine Stanley No. 610 eggbeater (wish I'd found it before paying eBay retail for one; still, my current favorite eggbeater), and another tool I shall not describe except to say that the maker's name is "Makita."


img

Re: Disston squares

#2

Answering my own question

Bill Houghton, Sebastopol, CA

>A little eBay research tells me they're not particularly collectible - prices seem to run $10 max. So, two pretties.

Re: Disston squares

#3

Re: Answering my own question

Kevin French, Antrim, NH-

>Nice find Bill. A fell'a can never have too many pre'dy squares, at least that's what I keep tell'n myself. And if their square all the better.

Re: Disston squares

#4

Well, I guess

Bill Houghton, Sebastopol, CA

>I was conditioned early to use a combination square (and continue to do so even in carpentry, which bemuses my son, who does it for a living and uses one of those aluminum speed squares), and normally use a 12" and a 6" combo square at the bench, with occasional use of a really little 2" engineer's square.

So the try squares become decorative - which, of course, they are - rather than functional.

Digressing: I used to wonder why cabinetmakers' tool boxes had three or four try squares in different sizes, until I realized how often I adjust my combo square to fit spots where I don't need the full length of the rule. The traditional maker, not having that adjustability, got there by having multiple squares. Duh.