Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

New Saw

Posts

Re: New Saw

#26

sent a link to your email...

Alan DuBoff

>

Re: New Saw

#27

Re: New Saw...ROB...potential problems

Marv....... Northern California Lake Co.

>There has to be some flexing out at the toe end of each saw. The pictures on your website show the saws not being parallel to each other. When a cut is started toward the toe end, then as the saws are pulled back, it appears that the cutting edges will want to go off line and then as the saw cut is cut into the wood, the blades will tend to bind as they are pulled and pushed forward.

Another potential problem might be the amount of effort it takes to push three saws at once and to have them all cut at the same rate, especially as they become dull. One saw might dull faster than one of the others, causing the duller one to pull to one side.

Wood is not always consistant in hardness from one side of a board to the other. This too could cause the outside saw to pull to one side.

No doubt a lot of clever design went into the tool, but from just a practical stand point, I can see some operator problems there.

Marv

Re: New Saw

#28

Maybe they're/it's pull rather than push?

Pam Niedermayer, Austin, TX

>

Re: New Saw

#29

Re: Maybe they're/it's pull rather than push?

Marv....... Northern California Lake Co.

>Pam,

If the rake was reversed so they would cut on the pull stroke, it would reduce some of the potential problems.

Marv

Re: New Saw

#30

I like

Bill Houghton, Sebastopol, CA

>"...and the tips of each blade positioned with no loss of useable cut length!"

It sounds so reasonable until you start trying to figure out what it means.

Re: New Saw

#31

You can tell

Dan Donaldson

>If you have been around Woodcentral for quite awhile if you got all of the references in the referrals. ;-) (maybe Alf from another source.)

Re: New Saw

#32

Re: 3 blades two hands?

Edward in Vancouver

>With three blades, shouldn't it have two handles?

And maybe laser tracking?...............

Re: New Saw

#33

Have you ever ..

Derek Cohen (in Perth, Australia)

>.. heard me use a word like "bonza"?!

Rob, the word is "beaut", and then you add "mate" at the end ... "That is a real beaut saw, mate!"

Now the REAL news is that LV have released new options for the dovetail saw.

I have a special one with a high cutting angle on the teeth for our local interlinked hardwoods. Each tooth was specially hollow ground at 62 degrees (special attachment for the LV Honing Guide) and then microbevelled. No tearout at all!

Just A-mazing!

Regards from Perth

Derek

Re: New Saw

#34

Re: New Saw...ROB...potential problems

Rob Lee

>Marv -

Believe it or not - we built that too...! We left it off for the AFD treatment, as it made the entire thing too complex... but it does exist!

Cheers -

Rob

Re: New Saw

#35

Too right, Cobber!

Rob Lee

>

Re: New Saw

#36

Totally Dude!

Scott Burr in Ben Lomond, CA

>