Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Update on Brace/Driver/Toolbox

Posts

Update on Brace/Driver/Toolbox

#1

Update on Brace/Driver/Toolbox

Derek Cohen (in Perth, Australia)

>Almost done!

Only the wooden hinges to make and install. I had hoped to get them done this weekend, but ran out of time (isn't it always the way?).

It's come out pretty well. The only let down is a slight gap, about 1/64", in the centre of the lid-base join. It was a perfect fit when I did a dry fit, but the lid must have bowed very slightly when I clamped it together. This is not unusual. Ordinarily I would just plane it flat, but there is no leeway at all to do this. Tolerance were always going to be tight, and there is about a 1/32" clearance inside the box. So I am just going to have to contain my perfectionism and live with it.

Here are a few pictures.







And a side view for the wood contrast (Jarrah and Tasmanian Oak) ..



Regards from Perth

Derek

Re: Update on Brace/Driver/Toolbox

#2

Re: Update on Brace/Driver/Toolbox

Marv....... Northern California Lake Co.

>Hi Derek,

Love the box. The little drawer is cute. Beautiful wood grain.

Looks like you might have grappled with a good method for holding the tools in place with the use of leather straps.

I think I might have toyed with some thoughts about matching wood cradles with felt for cushioning for preventing marring of your tools.

Great job,

Marv

Re: Update on Brace/Driver/Toolbox

#3

Re: Update on Brace/Driver/Toolbox

Derek Cohen (in Perth, Australia)

>Thanks Marv.

Here is a little more detail on the stands.

The pictures I posted may not convey this, but the brace and driver rest on stands ...



These are made from Jarrah rods I turned, then shaped with rasps ..



Strips of leather (from an old belt) were screwed from the rear (pictured on left). They clip on to a brass "knob" I made out of the end of split pins (pictured on the right)...



The reason for the leather straps is that the box and contents will be shipped in the mail, and I do not want the contents moving around.

Regards from Perth

Derek

Re: Update on Brace/Driver/Toolbox

#4

Re: Update on Brace/Driver/Toolbox

Marv....... Northern California Lake Co.

>Hi Derek,

The round stands makes good sense. I'd still be concerned about the wood to wood contact. A few of the woodworking tool suppliers offer various size felt stick-on pads that might work.

Thanks for the pics,

Marv

Re: Update on Brace/Driver/Toolbox

#5

Re: Update on Brace/Driver/Toolbox

Dan Donaldson

>I will send a separate e-mail with my address so that it doesn't get lost when you mail it ;-)

Nice box and brace. Could you post a bit of detail on the wooden hinges you are using?

Re: Update on Brace/Driver/Toolbox

#6

Re: Update on Brace/Driver/Toolbox

David Brown

>Derek,

This is just beautiful. I love the grain match on the front, even in the little drawer. I'd also like to see details of the wooden hinge when you get it done.

Regards,

--Dave

Re: Update on Brace/Driver/Toolbox

#7

Way Cool

roninkokomo

>