Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Tips on sharpening/tuning LV Cabinet Scraper

Posts

Tips on sharpening/tuning LV Cabinet Scraper

#1

Tips on sharpening/tuning LV Cabinet Scraper

Stephen Kirk in Quakertown PA

>After finishing a class where I used my first cabinet scraper, I realized I really needed one. I pickep up Lee Valley's scraper and set to sharpening and forming the burr. I'm still getting a mix of shavings and dust as well as a rather rough surface. I'd like to do near finish work with it. I'm wondering what else I can do to make it cut nice. I know they certainly can perform well, so I figure it's just me.

To hold the blade on the little 45 deg bevel during honing, are there any userful tricks? I was thinking of beveling a block of wood and holding the blade against it for a consistent angle.

Also, how critical are the burr angles. I just kinda eyeballed 15 deg, so maybe I'm off there.

I picked up the LV Mark II jig at the same time, but unfortunately the scraper blade doesn't fit in it. Hopefully I can get some consistent sharpening on my chisels/planes though.

Re: Tips on sharpening/tuning LV Cabinet Scraper

#2

Re: Tips on sharpening/tuning LV Cabinet Scraper

Alex Grigoriev

>LV also makes a file holder for 90 and 45 degrees filing: 05M07.01

Re: Tips on sharpening/tuning LV Cabinet Scraper

#3

Re: Tips on sharpening/tuning LV Cabinet Scraper

Steve Marino

>I just started using a Stanley No. 80. The block of wood trick worked pretty well for me.