Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Electrolysis Improvement

Posts

Electrolysis Improvement

#1

Electrolysis Improvement

Tom MacGregor

>Since electrolysis used to derust tools tends to be "line of sight" I wondered if it was possible to improve the line. I picked up a salvageable V&B 907C on ebay and wanted to dunk the whole body at once, not my usual flip-it-in-the-bucket routine. I bought a cheap (under $5) plastic trough for soaking wallpaper long enough to immerse an object up to 30 inches long. A short chunk of sacrificial iron concentrated the rust removal on less than 1/4 of the plane body. I took a 5-1/2 foot long piece of 1/4 inch iron rod and bent it into a long U around the trough and hooked it up as shown below. I got bubbles the full length of both sides of the plane! I will note, however, that it's very easy to make a BIG mess if you're not careful dumping the liquid out of the trough. Please DAMHIKT.


img

Re: Electrolysis Improvement

#2

Re: Electrolysis Improvement

Bill Houghton, Sebastopol, CA

>Cool - good idea.

You can buy those big troughs used for mixing concrete or compost and suchlike in home centers - about $5-10. If you put your wallpaper trough in one of those and dumped it into your storage container while in the larger container, it might contain the mess.

Re: Electrolysis Improvement

#3

Nifty Idea! Thanks!

Scott Burr in Ben Lomond, CA

>

Re: Electrolysis Improvement

#4

Re: Electrolysis Improvement

Marv....... Northern California Lake Co.

>Bill,

Do you use a battery charger for your power source?

Thanks,

Marv

Re: Electrolysis Improvement

#5

I have yet to try Electrolysis

Bill Houghton, Sebastopol, CA

>I was responding merely to the problem of not slopping stuff all over the place - something (the slopping) with which I have oodles of experience.