Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Rockwell/Delta 34-450

Posts

Rockwell/Delta 34-450

#1

Rockwell/Delta 34-450

Jarrad

>I have a 10" Rockwell/Delta saw. Does anyone know of a source for parts?

Also if anyone has a pdf of the breakdown of this saw, I would like to possibly copy it. I also have a Porter Cable 12" miter saw that is out of calibration. I have tried to calibrate it but it is at the max on adjustment. If you have any parts for this table saw; motor cover, truniun parts, I wold be willing to purchase these. Thanks for any help.

Re: Rockwell/Delta 34-450

#2

Re: Rockwell/Delta 34-450 *LINK*

Bill Houghton, Sebastopol, CA

>Although many of the folks on this forum use power tools at least part of the time, you might get better luck posting over on the general message board.

I think you can find links to parts and maybe owner's manuals at the link below, although, in my opinion, their parts and literature support isn't what it used to be.

If your saw is old enough, you might also find some help at Old Woodworking Machines, www.owwm.com


Delta's main page

Re: Rockwell/Delta 34-450

#3

Re: Rockwell/Delta 34-450

Michael Wilkins

>I just replaced that same saw with a sliding tablesaw. I got my manual and parts breakdown from the OWWM site. This site has reprints of many older machine manuals, and where I got mine from.

Re: Rockwell/Delta 34-450

#4

Re: Rockwell/Delta 34-450

ThomD

>A little off topic, but: Last year I bought a NOS quality Beaver (Rockwell up here) TS for 40 Canadian, right off craigslist. I think I got the price down to 30 bucks since I was buying a few things at the time. So that is one way to get a lot of parts.

Re: Rockwell/Delta 34-450

#5

Re: Rockwell/Delta 34-450 *LINK*

Bob Entwisle in NJ

>OWWM is probably a good place to start for parts and info.

Here's a link to one on the OWWM website.


http://www.owwm.com/photoindex/detail.aspx?id=2040