Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Rust questions: block plane

Posts

Rust questions: block plane

#1

Rust questions: block plane

Bill Houghton, Sebastopol, CA

>I went to a drop-in garage sale (that is, phone ahead and be a sole customer) yesterday and came home with a few items (including - I'm a little embarrassed - my fourth Stanley router plane, this one a 71-1/2, 1906-1910 production). I thought one of them was a Stanley No. 65-1/2 knockoff, but, as I examine it more closely, I grow more confused.

It's pictured below - the bottom plane in the pic. Length, general shape of castings, etc. are all identical to the No. 65 above it. The body casting has a "B" near the lever cap screw; the lever cap has "331" on its underside. The iron looks to be a notched-rectangle-logo Stanley.

The big difference is in the adjuster knob (pictured from another angle in the next message in this thread). I've never seen anything like this on a Stanley before. Is it an uncommon Stanley knob, or did somebody bust the knob off and fabricate their own replacement? The knob bottoms out on the body before the adjuster runs out of room. I'd intended this as a carpentry plane, so if this isn't a collectible tool, I may cut 1" off the heel to give the adjuster elbow room.

??


img

Re: Rust questions: block plane

#2

The adjuster knob

Bill Houghton, Sebastopol, CA

>The knob on my new plane (left in photo) looks like it came off some gas valve or something. It's a clean attachment, which means little - the retired carpenter from whom I bought it talked about growing up with his dad doing everything on a house from foundation to roof.

Anyone familiar with this knob style?


img

Re: Rust questions: block plane

#3

Hmmmm, looks like a...

Scott Burr in Ben Lomond, CA

>Replacement to me.

Re: Rust questions: block plane

#4

Re: The adjuster knob

Andy Lincoln,in Dearborn,MI

>Bill,

Just a quick guess here but it looks to me like a washered wingnut that has been groud/filed to relieve the edges/wings to a more confortable shape.

Andy

Re: Rust questions: block plane

#5

Replacement IMHO

Bob Demers

>

Re: Rust questions: block plane

#6

I thought...

Ellis Walentine, Host

>...those screws were some oddball pitch? Or was it the screw that holds the chipbreaker? 1/4-13 or something odd like that.

Ellis

Re: Rust questions: block plane

#7

More complex

Bill Houghton, Sebastopol, CA

>It's actually two different diameters at two different pitches. The smaller one threads into the body, and the larger one into a slide with a little bump on top that fits into the milled slots on the cutting iron. The difference between the two pitches drives the slide. A complex solution that must have made sense to some Stanley engineer, because it's used more than once.

I've concluded that Scott, Andy, and Bob are right - the shank on the original is about 1/4" longer than on this new one. I think somehow the original knob came off, and a previous owner cut the shank shorter and welded this replacement on.