Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

Making my carcass groovy; A question

Posts

Making my carcass groovy; A question

#1

Making my carcass groovy; A question

Patrick Gibbons, Katy, TX

>Peace and love WCers. Starting a new project- a case with two shelves, two drawers, a box top and two hidden compartments. Will be rolling some joints of the dovetail variety and started to wonder; Should I groove, dado and rabbet before I dovetail? Does it even matter? Silly beginners everywhere are dying to know. Lay it on me, brothers and sisters.

Re: Making my carcass groovy; A question

#2

You just get back from San Fransisco?

Scott Burr in Ben Lomond, CA

>Or is it just another flash back? Personally I like to cut (or roll as you put it Dude) the DT's first. makes easier to marks the tails or is it pins? Ahhh, joints make me loose my already short short term memory.

Re: Making my carcass groovy; A question

#3

Re: Making my carcass groovy; A question

Bob Demers

>Groovy man !

Depending on the application, I would do my groove first, it help locate the dovetails where it would show less, you still end up with a small hole, left to be covered as in this utility box I made for my storing my stack dado (yes, these are handcuts) but you get to locate it where you want, i shoot for approx middle of my pins

If you put up a false front, then no biggie its covered.

If not, half blind dovetails or a stopped groove would do it.

Bob, who say groove on man (wow, im having flashback to the sixties :-)


img

Re: Making my carcass groovy; A question

#4

Re: Making my carcass groovy; A question

Patrick Gibbons, Katy, TX

>This is on a carcass, not drawers. It seems to me that it doesn't matter. Just wondered if there was some overwhelming argument either way.