Some workbench top progress
wilbur
>I made some headway in gluing up my workbench top this weekend. I learned just how much wood can twist and bow after you do initial milling. I also got a lot more practice at correcting this twist with hand planes, if you know what I mean. Although I know I know this, I am really surprised as to how quickly I can square up something this large with hand planes. In some ways, it was easier than the initial milling up with my jointer/planer combo.
The other thing I learned is that if one of my planes is working in a less than optimal manner, I know how to correct it. For some reason, though, I insist on just plowing ahead instead of stopping to tune up the plane, until I get to the point where I just have to do it. Then I find out that I'll zip along three times as fast as I was.
As you can see in the picture, I'm also learning the true meaning of the phrase, "You can't have too many clamps." I placed an order for some more today. Hopefully they'll get here in a timely manner.
All together, there will be eight 4x4's going into this benchtop. I'm planning on gluing one additional beam a day, partly because I only have so many clamps, partly because of space issues (the picture really shows the entire width of my shop) and partly because I want to get a full day of drying time for the glue, just in case I didn't take care of all the twist. I'll probably do another set of three separately, and then finish up with the remaining 4x4s.
To get going on this, I clamped together most of the 4x4's together on the sawhorses to provide a temporary work surface, squared up two of the beams, and then unclamped the other 4x4's to give me room to use the sawhorse as a support for the glue up. In fact, I had put the bar of the clamp on the top side so it could be used as a planing stop.
Stephen's suggestion on jointing the top of my sawhorses was also really helpful. Thanks, Stephen!




