Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Clock face sources

Posts

Clock face sources

#1

Clock face sources

Michael Stadulis in Southern NJ------WebKitFormBou

>If this is a duplicate post, please accept my apologies.

Can someone suggest a source for antique reproduction clock faces for mantle or grandfather clocks. The faces that I see simply look too new ands perfect. I'm looking for something that looks old...yellowed and hand painted.

Any suggestions are welcomed.

Mike Stadulis

Re: Clock face sources

#2

Re: Clock face sources *LINK*

Scott in Douglassville, PA

>Hi, Mike -

Have you tried Clock Prints?

Scott, who drew his own...


Clock Prints

Re: Clock face sources

#3

Re: Clock face sources

Bill Tindall, E.TN

>There are people that hand paint faces. They look wonderful, but they are costly. If you are looking for such a face I have two sources. One is Mack Headley Sr.'s wife who is located near Winchester VA. The other source is in SC and I would need to look up info on this person.

Re: Clock face sources

#4

Painters...

Scott in Douglassville, PA

>I have a few written down, too - lemme know if'n I should look 'em up fer ya...

Re: Clock face sources

#5

Re: Clock face sources - make your own of metal...

John Aniano - in NJ...

>Michael,

For certain types of tall case (grandfather) clock dials, many were made of brass and etched. Now, don't say that is too hard to do - I made several including a tall case clock face, with moving eyes on the sun/moon at the top.

Start with sheet brass of some nominal thickness, say 16ga. Cut to the full size of the dial. Clean the front surface well and coat with a layer of resist, a lacquer that resists the etching acid to be applied later. Scratch through the resist with compass points, ruler-guided scribes, etc., until the dial pattern of numerals and rings are to your satisfaction. Make sure you sign your name! Then use a brass or copper etchant to take away the surface of the metal exposed through the resist. Wait until the level is just below the rest of the surface and neutralize the etchant. Use a solvent to remove the lacquer and then heat the dial and apply a coating of black sealing wax or other contrasting material to the etched regions. When cool, level out the sealing wax using sandpaper and a wood block. Buff up the metal surface or use a scotch-brite pad to give it some texture. If you are really into this and cannot get enough of metal working, find the chemicals to do a thin silver plating of the brass and this makes the contrast between the filled etched regions even greater.

The chemical etchant was easily available years ago at Radio Shack for making printed circuit boards. I can't even remember what it was called - probably not great to breath or work with - I do recall using heavy rubber gloves.

Or you could paint the dial...

Take care,

John

Re: Clock face sources

#6

Ferric Chloride

Dan Donaldson

>