Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Mortice bottom cleaning chisel

Posts

Mortice bottom cleaning chisel

#1

Mortice bottom cleaning chisel

Derek Cohen (in Perth, Australia)

>I was chopping a few mortices yesterday. They were small and difficult to clean out. For years I have been wanting a small swan neck chisel, but could not find one under 3/8". So, today, I decided to make a chisel for cleaning mortice bottoms. And it took just a few minutes.

The one I made used a hex/allen key about 1/4". All I needed to do was grind the foot into a chisel. Then I epoxied it into a reject marking knife handle. It is not heavy duty but it works reasonably well.



One mortice in a raised panel door I am busy on ..



More on the mortices in the next post ..

Regards from Perth

Derek

Re: Mortice bottom cleaning chisel

#2

Re: Mortice bottom cleaning chisel

Alexander Grigoriev

>Get a cheap chisel, and roll a burr on the edge. Works, too.

Re: Mortice bottom cleaning chisel

#3

Cute little thing!

Scott Burr in Ben Lomond, CA

>