Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

Sawing poll: near to far or far to near?

Posts

Sawing poll: near to far or far to near?

#1

Sawing poll: near to far or far to near?

Al

>I was in the work shop recently and took notice of my sawing habits.

Seems when I cut a dovetail I work from the near edge of the board to the far edge, but I'm more comfortable cutting a board to length starting at the far end of the board, working so that the heal of the saw is progressing along the line. (like ripping)

Seems intuitive to me, but how do others track a line with the saw?

Al

Re: Sawing poll: near to far or far to near?

#2

Re: Sawing poll: near to far or far to near?

Dean J in MN

>I try to follow two lines at a time. So dovetails, with the board in the vise, I start at the front corner. Same for tenons. Cross-cutting on horses I start at the far end and advance on the edge and face until I am all the way through the edge then hold that line and advance on the face line until I'm at a comfortable angle to continue the x-cut. (I do the same for rips on horses). On a bench hook I start on the far edge (as above) most of the time but allow the saw to follow the face further, then I rotate the board and cut the next corner out, repeat for the rest.

-Dean

Re: Sawing poll: near to far or far to near?

#3

Yes

Bill Houghton, overcast Sebastopol, CA again

>Like Dean, I try to follow two lines for any cut that needs precision. Like you, I cut big stuff from the far side first. If little finicky stuff works better starting from the near side, I do.

What I usually don't do until I'm halfway through the cut is remember to bring the saw up to 60 degrees for long rip cuts. Then I remember, and it's SO much faster, even with a crosscut saw.

Re: Sawing poll: near to far or far to near?

#4

Me too

Roninkokokomo

>