Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

live edge lumber

Posts

live edge lumber

#1

live edge lumber

Howard Pollack

>Hi- I have a slab of kiln dried live edge lumber with the bark still on it. I'd like to make a mantle shelf out of it with the bark removed and the remaining natural edge retained (like Nakashima). Does anyone have any ideas about how to handle this other than carefully pulling and scraping the bark off? Is there a particularly good way to retain the remaining edge? Thanks -Howard

Re: live edge lumber

#2

Re: live edge lumber

ThomD

>Bark comes off depending on the time of year it is harvested. It either just falls off or you do have to remove it bit by bit. It's possible that some steam or soaking in water would help. Th eonly other thing I would try is snad blasting. I bought one of those cheap SB attachments, but I haven't tried it.

Once the edge is clean there isn't anything special you need to do to preserve it. It's just regular wood. I;ve turned tons of natural edge bowls and they are perfectly durable. Getting the bark off is the best first step since it holds moisture and so forth. Though solid bark edges will hold up for years. The only thing about natural edges is that depending on how tangent or radial the board is, and other factors, they can be pretty dangerously sharp.

Re: live edge lumber

#3

"Snad blasting"? I love typos!

Hank Knight

>

Re: live edge lumber

#4

Ellis Walentine

Options after removing the bark

Ellis Walentine

>The cambium layer, just under the bark, often appears as a thin brown membrane on the surface of the live edge. Depending on the appearance you're after, you might decide to clean this off, which you might try with Scotch-Brite if you don't want to remove any sapwood tissue. If the edge is irregular or prickly, you might want to use a spokeshave or rasps to make it flow more smoothly. This is often desirable for edges that will be in contact with people, such as the edge of a dining table or coffee table.

Ellis Walentine, Host

Re: live edge lumber

#5

Re: live edge lumber

Stephen Shepherd in the State of Deseret

>It depends on the tree, what type of tree is the lumber from? If it is Hickory it will not fall off in your lifetime, nor that of every future generation.

Bark can also contain a lot of sand and grit that can ruin an edge tool. If you have a barking spud, a large flat chisel like tool with a long handle, they work.

You can use a drawknife if you have one. You can also pound on the bark with a round stick like a baseball bat, hit it directly across the grain, sometimes this will loosen the bark allowing it to be stripped easily.

Good luck.

Stephen

Re: live edge lumber

#6

Could be worse...

wilbur

>...it could have read "nads blasting".

Ouch!

:@)

Re: live edge lumber

#7

Re: live edge lumber

R.J. Whelan

>Howard ... you didn't mention the species but I have had luck with the following sequence of attack:

1. Beat on the bark with a dowel or pipe

2. Remove all loose bark

3. Wire wheel in a drill motor

4. Flap sander in a drill motor

5. Hand sand

Good luck ... rj

Re: live edge lumber

#8

Omar was right

Hank Knight

>That's funny!

Omar was right:

The moving finger types, and having typed, moves on.

Nor all your piety nor wit can lure it back to cancel half a line.

Nor all your tears wash out a word of it.