Appreciating the old layout tools
Bill Houghton, sunny in Sebastopol, CA
>For years, when I've needed to lay out a 45 degree line, I've used my combination square. This gets tricky sometimes when working at the end of a piece of stock.
Several years ago, I picked up a Stanley miter square at an estate sale, using Sir Edmund Hillary's Everest-climbing excuse*. Until today, I hadn't used it.
Today, I needed to hand cut some miters on 3/4" by 1/4" screen molding, and the combo square was just too awkward: I was working at the end of the stock, so I had nothing to butt the square's head against, and I was going to have to run a line up inside the rule anyway, where it's hard to reach. Then I remembered the miter square. What a revelation! I could hold it easily along the length of the stock, down away from the end, and mark anywhere without having to squinch the pencil into a restricted area.
To fellow rust-hunters: if you see one of these at a garage sale, jump on it. It is NOT an obsolete tool since replaced by the combination square.
*For those not familiar with his response when asked why he climbed Everest, he is reputed to have said, "Because it was there."



