Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

OT - UHMW plastic questions

Posts

OT - UHMW plastic questions

#1

OT - UHMW plastic questions

Bill Houghton, sunny in Sebastopol, CA

>Did the vacuum cleaner repair today, using a flat furniture glide 2-1/2" in diameter fastened to two layers of 1x pine. Glides well, but it can't climb transitions, like onto a rug.

I'm thinking of finding the maple rolling pin I scrounged somewhere and cutting a part-circle to use in place of one layer of pine, then putting UHMW plastic strips on it.

I've never even seen this material, much less used it. Is it resistant to picking up grit? Does the adhesive used on the strips hold well over time?

Re: OT - UHMW plastic questions

#2

Re: OT - UHMW plastic questions

Tom MacGregor

>UHMW is abrasion resistant and stays slippery. It machines easily although, depending on the method of cut, can generate a lot of fuzz that can be trimmed with a utility knife. I've chamfered edges & done light trimming on it with planes, too. I've used the thin adhesive backed stuff on fences with no problem, and a farrier friend used some for glides under some very heavy slide-out stuff in his trailer with no problem. I'd give it a try.

Re: OT - UHMW plastic questions

#3

Thanks

Bill Houghton, sunny in Sebastopol, CA

>As always, this place offers a wealth of experience with making/doing stuff.

I knew I saved that rolling pin with the busted handles for some reason...