Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

OT - clock maintenance

Posts

OT - clock maintenance

#1

OT - clock maintenance

Bill Houghton, Sebastopol, CA

>We had some maintenance done on an old mantel clock from LOML's family a couple of years ago, and it ran fine until recently. Now, it runs for a few hours and then kind of loses time. The winding key is operating against pressure, implying that the spring's OK.

Should I be oiling it? Is there a special oil? Or is this a dark art, and we should take it back to the nice little German clock guy who did the work before?

Re: OT - clock maintenance

#2

Jack Guzman from Maine

Re: OT - clock maintenance

Jack Guzman from Maine

>Bill,

I'm not an expert but I do some clock repair.I've been exploring this area for several years now.One thing I have learned though is that clocks need regular cleaning.Oil dries,dust settles in,whatever.Clocks get dirty with age.The pivot points on all those gears have very small clearances and when dirt builds up,it puts resistance on the gears,so the clock slows and eventually stops.The best way is to have a clock shop clean and reoil it.The movement has to come out to do this and critical parts can get out of adjustment.Do you have a picture of the clock?---jack

Re: OT - clock maintenance

#3

Jack Guzman from Maine

about oiling

Jack Guzman from Maine

>I got ahead of myself. You asked about oiling.You can oil your clock.Merritts antiques sells clock oilers.It's a clear tube dispenser with a needle tip.They come full of clock oil and only cost a few dollars.You put one drop on each pivot(where the shaft of the gear comes through the plate).This may get your clock back to snuff. If not, see my first post.---Jack

Re: OT - clock maintenance

#4

Re: about oiling

Greg B�tit Crown Point NY

>There is a clock shop in Vergennes, VT. The proprietor is an old tool nut (has a corner of his shop devoted to selling them), and restores one lungers for fun. When you buy a watch battery at the drug store, they tell you to take it to him to get it installed. He doesn't charge for this.

That's how I met him. After he put the battery in, I looked his tools over, but didn't see anything I needed. But I have a grandmother and a grandfather clock that were sitting around needing attention. So I thought I should give the guy some repair business. When I told him I would bring them in for repair he talked me into buying an oiler exactly like the one Jack described, and showed me to place one drop on each pivot as Jack describes. The clocks run fine now.

If you're ever in Vergennes, stop in the clock shop. I don't know how he stays in business, but I sure hope he does.

While you're at it patronize the shoe repair shop that opened this Summer in Vergennes. I know of one other in Vermont - in Rutland.

greg

Re: OT - clock maintenance

#5

Wandering OT: old line small businesses

Bill Houghton, Sebastopol, CA

>There used to be a guy here in our little town who repaired magnetos. Somewhat of a niche market, mainly old (pre-WWII) cars; back when we had a VW, I took the generator to him for repair of some kind, at about 1/4 the cost of buying a replacement.

I don't know how some of those little business folk stay at it, other than love, but it's always sure a delight to find them, and not just for the $$ savings, but for the window on their passions.

Re: OT - clock maintenance

#6

Hey Greg

VTAndy4

>FYI there is also an old-school shoe repair shop in Winooski!

-Andy