Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Stanley saw set

Posts

Stanley saw set

#1

Stanley saw set

Bill Houghton, Sebastopol, CA

>This is the saw set I picked up today. No visible model number, and it's the dread maroon color that signals late Stanley stuff, but for $1, not a bad deal, I think.

The anvil moves up and down, driven by an eccentric that claims to accommodate 4 - 16 teeth per inch.

Just in front of the base of the "trigger" is a little plate, moved in and out by a knurled nut, that looks to be intended to press the saw plate against the base of the anvil, for consistency in setting.

The plunger's beat to death - looks like it was used to drive nails - and would need reshaping.

Anyone recognize it?


img

Re: Stanley saw set

#2

Another view

Bill Houghton, Sebastopol, CA

>The original clamping screw for the eccentric is missing - I would need some kind of shouldered screw to fit the hole, which is considerably larger than the machine screw tapped in the anvil; and probably a knurled or wing head on it, so as not to need a screwdriver.

The existing solution's not quite working, I think, because the eccentric works against the machine screw only some of the time.


img

Re: Stanley saw set

#3

Re: Stanley saw set

Bob Barkto

>Stanley 42 W or S most likely.

Check the inside of the rear grip for a model number, they're typically cast into the metal. Might not be there on the very late models?

The screw looks proper from here, at least the slotted head. There should be spring tension on the anvil adjuster, no tools needed to adjust.

Hope this is helpful.

Re: Stanley saw set

#4

Re: Stanley saw set

Marv....... Northern California Lake Co.

>Hi Bill,

What you have is a Stanley 42W. I have one but prefer the 42X. The 42X has a spring tensioned plunger that clamps against the blade just before the hammer bends the tooth. The 42W that I have tends to slip upward on the tooth as I bend the tooth, where as the 42X doesn't. To help prevent the adjuster from turning as you tighten the screw, put a flat washer under the head of the screw and give it a drop of light oil.

You might check on eBay to see some pictures of one for sale so you can compare.

Marv

Re: Stanley saw set

#5

Re: Stanley saw set

Bob Barkto

>Here is an image of a 42W in new condition.

This shows the order of assembly of the parts that make up the anvil adjuster.

The screw doesn't get tight enough to stop the eccentric from rotating. The spring applies enough pressure to keep the adjuster from moving during use.

Unless the spring is shot!


img

Re: Stanley saw set

#6

or missing...

Bill Houghton, Sebastopol, CA

>My version has no spring, but has twice as many washers. I'll have to dig through my spring collection and see if I can find a suitable replacement.

Thanks for the pic - this helps.