Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Ax

Posts

Ax

#1

Ax

Stephen Shepherd in the State of Deseret

>A friend of mine picked this up at a local swap meet for $8.00, not a bad price. It is fairly flat on one side, laid steel bit and poll, which is deformed from hammering. It appears to be made of several pieces of iron forge welded together and the laid steel parts.

The handle is new. I think it is a hewing ax, the eye is straight and with the double ears could be configured right or left hand.

Stephen


img

Re: Ax

#2

Re: Ax Touchmark

Stephen Shepherd in the State of Deseret

>Here is the touchmark, can anyone make it out?

Stephen


img

Re: Ax

#3

Re: Ax Touchmark

Bob Demers

>Well, I tried all my usual tricks on it, play with brightness, contrast, invert the colors, rotate the pictures etc...

I don't think there is actual characters on that marks, rather the last two symbols are distinctively three overlapping half circle

Those symbols may be repeating, but the other ones are not so neatly done as the last two.

Bob

Re: Ax

#4

Re: Ax

Todd Hughes

>Hard to tell from that photo and i could be wrong but looks like a felling axe to me rather then a hewing axe. A hewing axe would be sharpened with a single bevel like a chisel and one side would be perfectly flat. The axe eye should be slightly offset to and not centered down the middle of the axe.

...Is an old style of axe head but hard to date somthing like this for certain because in Europe they were made pretty late...Lots of these old axes have been brought into the country in the last 10 years or so with other antiques

...While sort of interesting to see what the touch mark is even if you could make it out probably wouldn't tell you much about the axe.Lots of small makers out there and no record of most of them or thier marks.

...$8 ain't much money but does look pretty pitted to me....Todd

Re: Ax

#5

Re: Ax

Stephen Shepherd in the State of Deseret

>Todd,

It is a hewing ax, with a bevel on one side only. Here is a photograph of the bevel. The eye has been distorted (enlarged) over the years, so the flat side is not real flat. And the poll on the end is mushroomed quite badly.

The steel is forge welded on one side only (the flat side).

Stephen


img