Sometimes I think we fuss too much
Bill Houghton, Sebastopol, CA
>I drilled some extra dog holes in my bench today - the existing spacing was too great, so I drilled holes halfway between. I was in a hurry (seems like I always am anymore), so I just put a forstner bit in a drill and went at it. Unfortunately, I fairly consistently slanted the drill toward me a bit, so the bench underpinnings interfered with the holes on the bottom; so I went back (forstner bits are great for this) and reamed out the holes.
Lee Valley round dogs, by the way.
End result: the only part of the holes that's 3/4" is the very top. The rest of the hole is not round, but gives more the impression of a wolverine chewing its way out of a box. I can wiggle the bottom of the dog around a good 1/8" on some of the holes.
But so far, using them to hold boards on which I was doing some pretty vigorous planing (boards clamped between dog and Record end vise), they work fine.
This isn't what I'd want to do on a permanent benchtop, but this bench is moving toward replacement in a year or so, so I feel free to fool around and get the job done. It was a useful lesson. We may get too fussy sometimes.



