Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

Holdfast for a Nicholson?

Posts

Holdfast for a Nicholson?

#1

Holdfast for a Nicholson?

Bjenk Ellefsen

>Good morning everyone,

I have a question for you all. The thickness of my bench is less than 1 1/2 inch as I have used construction lumber for it. I am looking at available holdfasts and Phil Koontz and Jake Pogrebinsky's are good for a top that is at least 1 1/2 inch. The Gramercy need a top that is at least 1 3/4.

I doubt any of the two will work well on my bench. Any suggestions?

Re: Holdfast for a Nicholson?

#2

Re: Holdfast for a Nicholson?

joel

>The Gramercy should work on a 1/1/2" bench but all you really need to do is add a board under the holes to make the thickness around the holes a little greater and you can use anyone's holdfasts.

Re: Holdfast for a Nicholson?

#3

Re: Holdfast for a Nicholson?

Adam Cherubini

>My jorgensen's hold okay. Not great. What i do most often is put pegs in the apron. I most often use the holdfasts in the holes in the legs where they hold very well.

Adam

Re: Holdfast for a Nicholson?

#4

Re: Holdfast for a Nicholson?

Bjenk Ellefsen

>Thanks for the responses. Yeah, I was thinking that in the legs it would work perfectly and pegs sounds like a nice idea.

This morning, I was thinking exactly what Joel suggested: adding pieces of boards where the holes in the top are going to be. It should work nicely.

On another note, I have been working on a cupboard on the bench. So far, I love working on it. I found that it makes ripping so easy as I just need to hop on the bench and secure the boards with my knees. Planing is a charm because the bench is just the right height. I just need to stiffen it, install the upper stretchers and front vise, pierce holes and I am in business.

Re: Holdfast for a Nicholson?

#5

Re: Holdfast for a Nicholson?

Warren in Lancaster, PA

>Nicholson suggests "transverse bearers" "fixed to the side boards" under the bench top at regular intervals to support and stiffen the top. So if you have four or five of these crosswise pieces, you could make the holdfast holes go through them. You might even plan your bearers where you want holes.

Re: Holdfast for a Nicholson?

#6

Re: Holdfast for a Nicholson?

Bjenk Ellefsen

>Yeah, I could but I built it to be able to knock it down using Adam's design so the bearers are absent except for two upper stretchers attached to the legs.

Re: Holdfast for a Nicholson?

#7

Re: Holdfast for a Nicholson?

Stephen Shepherd in the State of Deseret

>Get the holdfast(s) first and if you have a thinner bench just drill a smaller than recommended hole. Test several size holes on a scrap piece of wood the same thickness as your bench top. No reason to experiment on the finished bench.

Stephen