Tormek owners: meet the ancestor of your grinder
Bill Houghton, Sebastopol, CA
>I picked this up today at a moving sale. Kinda neat, and works! I need to experiment a bit, see if the wheel, which is pretty glazed, can be dressed enough to work. If all is well, I have to figure out how to fit it in my shoplet.
The hopper on top is for water, which dribbles onto the wheel through a piece of copper tubing that's been collapsed to allow just a little (somehow, I'm dubious that the copper tubing is the original design). I think excess water may just drain out the bottom of the lower casting - hmmmm, not so good in a concrete floored shop. I guess I'd have to install a catch basin, if that's so.
The wheel turns up, counter to the direction of most wet wheels I've seen, and there's a bit of sponge in a little well in the body casting, right in front of the wheel - apparently, the maker didn't want it too wet.
The toolrest is flat, and tilted slightly into the wheel. I think this may have been designed for a specific application.
The nameplate, from Coburn mfg, of Muskogee, Oklahoma, USA, indicates that it's the "Rocket" model. The graphics lead me to think it dates from the 1950s.




