Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

A Question for Rob Lee...

Posts

A Question for Rob Lee...

#1

A Question for Rob Lee...

Stephen Shepherd in the State of Deseret

>I know that I originally complained a bit about your duck billed spoon bits, but I came to my senses and ordered a full set. I must say I am delighted in their performance. (I did have to dull the sides). I just bored a 5/8" hole end-grain into birch to repair a leg of a spinning wheel. The end where the hole was drilled was just under 7/8" in diameter, so there was little left on each side but I got the hole about 2 inches deep. This would have been difficult with other bits I have.

Here is the question, have you considered making some larger sizes? For chair making and other purposes larger sizes would be handy. Also a 1/4" would be sweet.

Stephen

Re: A Question for Rob Lee...

#2

Re: A Question for Rob Lee...

Rob Lee

>Hi Stephen -

Shoot me the additional sizes you think are desirable by email - and I'll see what we can come up with...

Pretty sure a 1/4" size won't be in the picture though ... don't think it would work well with the current design/mfg process....

Cheers -

Rob

Re: A Question for Rob Lee...

#3

Re: A Question for Rob Lee...

ThomD

>I bought them and couldn't get them to work, though I didn't try hard either, prefering to return them. I have the other ones, so my main motivation was a backup. I'd still get them if I could get them to work.