Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

I always wanted to make one of these...

Posts

I always wanted to make one of these...

#1

I always wanted to make one of these...

Stephen Shepherd in the State of Deseret

>so today, I did. It is called a deadeye and is a traditional come-a-long or turnbuckle. It can be cinched down and the loose end secured to hold it in place. They were generally used aboard ship.

I got the ropes wet and have them under pressure with the weight, the gnomon is 6 inches.

Stephen


img

Re: I always wanted to make one of these...

#2

Re: I always wanted to make one of these...

ThomD

>These are back in fashion today, if in new form. The advent of spectra to replace wire rope, has these back in the rigging to tighten down shrouds where with wire rope mechanical turnbuckles once dominated. Cool thing is that rolled fitting required a snazzy expensive machine while these are cheap to buy or make.

http://www.precourt.ca/

Re: I always wanted to make one of these...

#3

A little more detail would help the slower among u

Chuck Nickerson

>Is it just a rope looped through the holes? Does the mechanical advantage come from the friction of the rope truning the corners?

Re: I always wanted to make one of these...

#4

Re: A little more detail would help the slower amo

BobStrawn

>If you look at it, pulling the loose cord six inches, will only lift the bottom one inch. That gives six to one leverage. Friction causes a lot of extra work, so you probably lose about half the advantage. But still pulling 50 lbs to lift 150 ain't bad.

The friction would be less for a pulley, but this arrangement allows the friction to give you much better control on releasing the load.

Often the lifting a big rig of this type may take a few men to pull, but the lowering can be accomplished quite well by one.

Bob

Re: I always wanted to make one of these...

#5

Re: I always wanted to make one of these...

George Makowski

>Stephen, Have you made any cleats or blocks? I have made some cleats in the past (easy and fun) but not any blocks. It would be fune to hear from anyone who has built them.

Good rigging!

George

Re: I always wanted to make one of these...

#6

Re: I always wanted to make one of these...

Stephen Shepherd in the State of Deseret

>I have made a bunch of cleats, I have several behind my shop to secure the awning and one on my flag pole. They are great fun as you said and easy to make.

I have made both single and double sheave blocks and a couple of snatch blocks (one cool pulley). I also make a lot of toggles, this is all a result of having Ashley's Book of Knots, a book you don't want to set down with, with a ball of string, you may never get up.

Always looking for a better purchase.

Stephen

Re: I always wanted to make one of these...

#7

Snatch Block

Stephen Shepherd in the State of Deseret

>Here is a snatch block I made, its advantage is the rope does not have to be threaded through the block.

Stephen


img

Re: I always wanted to make one of these...

#8

Cleat

Stephen Shepherd in the State of Deseret

>This cleat secures one corner of an awning behind my shop, it is fixed with two nails (pre drilled) at angles to lock the cleat to the exterior wall. It is important to run the sheets around the cleat first before going over the top and it is secured with a hitch.

Stephen


img