Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

Removing modern plating

Posts

Removing modern plating

#1

Removing modern plating

Stephen Shepherd in the State of Deseret

>While it is increasingly difficult to find slotted screws, it is almost impossible to find them anything other that plated with zinc or something shiny. It is also hard to find iron (well mild steel) hardware such as butt hinges that are not plated.

I got some slotted screws from a large well known big box store and immediately put them into a cup of vinegar and placed it in the sun. After a hot work day (8 hours) all of the plating had been removed leaving a nice gray surface that easily rusts.

If I dry them off they remain a nice gray color, if I put them in a paper towel and let them dry, the next day they are rusty and look good for certain applications.

Stephen

Re: Removing modern plating

#2

Have you tried McFerrlieys?

Scott Burr in Ben Lomond, CA

>Please I don't know if I have the name spelt right.

Re: Removing modern plating

#3

Re: Have you tried McFerrlieys?

Stephen Shepherd in the State of Deseret

>Thanks Scott,

I don't know how to spell it either but last time I looked they didn't have much in the way of slotted screws and just about everything available is plated.

The vinegar trick seems to work fine. The plating is not that thick.

Stephen

Re: Removing modern plating

#4

McFeely's? *LINK*

David Barnett - SW Florida

>I like their square drive screws and long taper drills.


McFeely's

Re: Removing modern plating

#5

Re: Removing modern plating

Tony Zaffuto

>I've removed plating by running items through a sintering furnace at my plant. Took off plating and decarbed the steel also. I've used the screws, hinges, etc. on a tool box and gate hardware with excellent rusty results! I also tried heating with a Mapp gas torch, but you'll have issues with vapors from burning off the plating--much easier to run them through a controlled atmosphere furnace with proper venting!

The pieces I did with a torch, I quenched in oil which resulted in a really nice look.

A few years ago, when borgs started really taking over even here in rural PA, I stocked up on slotted screws from MSC--brass and steel. Basically good material and proper look, at least from the slot view:).

Stephen, in your studies of hardware, have you ever come across any pieces that had a "blackened" finish that was not japppaning or paint?

T.Z.

Re: Removing modern plating

#6

Re: Removing modern plating

Stephen Shepherd in the State of Deseret

>Tony,

Large hardware like strap hinges for man doors are usually oil blackened. However almost all hardware was provided 'bright', filed to a shine. It is a different shine than plating. Having a bright finish resists rust.

Stephen

Re: Removing modern plating

#7

Re: Removing modern plating

Tony Zaffuto

>Thanks Stephen,

Just curious from results I've gotten from dunking in oil and water. In my manufacturing process we use a "steam treating" process that gives results somewhat similar to "black oxide treating". Parts are heated to around 1400 degree F with steam then introduced. Gives a bit of surface hardening and a nice, somewhat even, dar gray color. Also acts as an anti-corrosion measure.

Tony