Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Kicking it - old school

Posts

Kicking it - old school

#1

Kicking it - old school

ThomD

>I bought a foot operated mortising machine. It isn't exactly as I remember the others I have seen here, but it looks serious enough to work, and apparently has had a long life in a sash shop already. The cutting action is a vertical plunge, while the chisel can be rotated through 180. If my hands were restricted to those motions I would most likely alternate strokes, keeping the bevel on the outside, until I had dug out a v shaped notch within the layout. Then I would alternate cuts with the bevel inside to widen the notch into a square pocket. There isn't any capacity to pry chips out, at least not with the machine.

The only thing that bothers me about this proceedure is that it seems a little busy as far as all the 180s are concerned. Can anyone describe a sensible proceedure, I haven't seen this kind of tool in action?

I bought it mostly because a machine of this general type is one of my father's main memories of his father's workshop.

Re: Kicking it - old school

#2

Re: Kicking it - old school

Stephen Shepherd in the State of Deseret

>Thom,

I owned a pair of these machines (well one was a hand tenon cutter) and found it easier to drill a hole first, helps with chip removal. I drill the hole near one end and make the first stomp. I would then reverse the chisel (180 degrees) and finish stomping the mortice by nibbling the rest of the waste wood out.

Stephen

Re: Kicking it - old school

#3

Re: Kicking it - old school

ThomD

>That sounds like cheating, but since I may have to sell my real mortiser to make room for this new toy, it may be very useful information. Thanks!!

Currently it's snoozing in the back of my truck so any evaluation or photos may be a while in coming.