Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

Here is the OWT I made.

Posts

Here is the OWT I made.

#1

Here is the OWT I made.

Derek Cohen (in Perth, Australia)

>Thanks to all who responded to my request for pictures of their OWTs... Old Woman's Tooth (or Old Hag's Tooth). This is what I came up with.

I had a amsll piece of Sepature left over from a cabinet I have just constructed. This is a Malaysian timber that looks very similar to Tasmanian Blackwood. It has stunning chatoyance and has a striking appearance.

The OWT is about the same size as the small LN and LV router planes. In this case it is 6 1/2" long and 3" wide. The blade is ground out of a hex key and has a cutting width of 1/8" (I wanted something small for inlays. I small be making a few more even smaller than this).



The blade is held in with a brass and steel knurled screw (one of my converted hose fittings!).



The underside and blade:



And compared with the LV and LV small router planes:



It feels solid and works well.

Regards from Perth

Derek

Re: Here is the OWT I made.

#2

Where'd you score the knob ?

steve mackay

>

Re: Here is the OWT I made.

#4

I'll be darned . . .

steve mackay

>You make that look do-able ! Been think'n through a lever cap to convert a mutt bench plane and shopping the lever cap but can't bring myself to pony up the $ 80.00. Now, I'm think'n I just need to score a piece of brass junk. Thanks for the food-for-thought !

Re: Here is the OWT I made.

#5

For smaller tools like spokeshaves

Bill Houghton, Sebastopol, CA

>you can also use various lamp parts, which (at least in the U.S. - don't know what's common in other countries) can be tapped from 8-32 to 10-24, possibly larger. I've used them on several metal spokeshaves and even my wooden mortise hinge plane.

Re: Here is the OWT I made.

#6

Looks real nice Derek,

Scott Burr in Ben Lomond, CA

>Does the knob push the blade forward into the wood to hold it in place?

Is there a threaded insert in the body of the plane that the knob screws into?

Nice job!

Re: Here is the OWT I made.

#7

Re: Looks real nice Derek,

Derek Cohen (in Perth, Australia)

>Hi Scott

The blade is held by the bolt pushing forward, like the LN and Stanley small routers, rather than by an eye bolt pulling back, like the ECE. The "problem" with the latter design is that it requires a thicker section to house the eye bolt. I was tempted to tap a thread into the wood but decided to use a metal insert for the most reliable durability.

Regards from Perth

Derek

Re: Here is the OWT I made.

#8

I thought so. Thanks!

Scott Burr in Ben Lomond, CA

>

Re: Here is the OWT I made.

#9

Re: Here is the OWT I made.

paul womack

>The biggest problem with hex keys (AKA Allen keys) as blades is lack of relief.

One could either do enough grinding to generate relief (optionally making the blade short to avoid making it too thin), or lean the blade forward in the holder.

Did you do either/both of these Derek?

BugBear

Re: Here is the OWT I made.

#10

Re: Here is the OWT I made.

Derek Cohen (in Perth, Australia)

>Hi BB

I ground about 7 degrees of relief. The steel feels strong, but to be on the safe side I made this 1/8" blade a little shorter than the 1/4" LV.

Regards from Perth

Derek