Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Price drop on over 1300 Rockler items

Trunk design question

Posts

Trunk design question

#1

Trunk design question

Bill Tindall, E.TN

>Do trunks typically have some arrangement for aligning the top(lid) with the bottom when the top is in the closed position, for example, a thin molding around the top that would lip over the bottom in the closed position, or interlocking rabbits where the top and bottom join? Or is it sufficient to just let the hinges align the top with the bottom which is what I would do on a small box?

Re: Trunk design question

#2

Re: Trunk design question

Warren in Lancaster, PA

>One option you might consider is a strip 1/4 or 3/8 X 2 mitered and applied on the inside of the bottom portion, sticking up over the edge maybe 1/2". A lot easier than rabbeting with dovetails involved and looks good too. You need not go four sides. If there is a molding around near the bottom on the outside, you could put one on the outside of the lid. If the bottom is unadorned, a molding outside the lid doesn't look so good.

Re: Trunk design question

#3

Re: Trunk design question

"RJ" Whelan

>Bill ... I built a "steamer trunk" for my mom about 20 years ago and installed a "lip" all the way around; the lip mated with a dado cut in the meeting face. I saw this detail in an old (very high end) steamer trunk I was copying. An old timer (cabinet maker for over 60 years) told me the lip was supposed to make the trunk nearly air tight and somewhat water resistant. My mom traveled over 30,000 miles over a ten month period (a lot of it at sea) and she told me here cloths never got musty from the dampness.

My 2 cents - fwiw ....... rj