Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

San Antonio Mission Woodworking

Posts

San Antonio Mission Woodworking

#1

San Antonio Mission Woodworking

Roy Anderson

>I just got back from a trip to San Antonio. I was on the lookout for woodworking items throughout the trip and I found some.

We took a tour of the old Spanish Missions there (circa late 1600's - early 1700's) and I noticed some hinges on the old doors. They didn't use normal looking hinges, but something that resembled a split brass fastener from a loose leaf binder.

The picture below shows how they drilled a hole in the door and the jam and linked some iron rods that had been bent over. Then they bent back the ends where they protruded from the holes on the other side of the door frame. This sounds incomprehensible until you see the picture.

I can't see why this system is better than a normal hinge, except that it doesn't require screws, which might have been difficult to fabricate in a frontier environment.

Any ideas?


img

Re: San Antonio Mission Woodworking

#2

Snip hinge

Stephen Shepherd in the State of Deseret

>This is a fairly early and simple hinge. They are basically two pieces of wire bent in half with a loop in the middle, similar to a cotter pin and interlocked. The ends of the wire go inside, are bent and clinched over like door nails to secure.

I have a couple of pieces that I have made with this type of joint. It has no adjustment, a little slop, but not bad and is very inexpensive.

Stephen

Re: San Antonio Mission Woodworking

#3

Jack Guzman from Maine

Re: San Antonio Mission Woodworking

Jack Guzman from Maine

>One of my neighbors has an old blanket chest with those type hinges on it. ---Jack