We value your privacy.
We use cookies to enhance your browsing experience, analyse site traffic, and personalise content.
By clicking “Accept all”, you consent to our use of cookies. You can also choose
“Essential only” or learn more.
>Here is a picture of the pine cradle in the thread below. The shoulders on the tenon were not quite right on two of the eight tenons. This one was off.
So with the croscut saw I carefully made a kerf next to the upright piece with the mortise and cut down to the cheek of the tenon a quarter inch. It has only one shoulder (bare face tenon).
>I learned a similar trick from Garrett Hack last Fall. Place a thin metal rule or a card scraper flat on the mortise piece and butt the edge against the tenon piece with the bad shoulder. Score all the way around the tenon piece with a knife, using the rule as the reference. Then plane to the score line with a shoulder plane. Voila! an even shoulder referenced precisely and consistently from the mortise piece.
>I do like your innovative handle though. We need to do some wheat carving on that sucker....I swear, wheat carve your handles and your saws will cut better. *grin*
>You know what I like about this? I like the assymetric shape of the cut-out. Gives the eye something to study and consider. A symmetric "{" would have looked bland.
Matching the shape of the cut-out on the leg is also a nice touch, and not one I would have thought of.
The glue line on the pine lamination looks a bit rough...must be the hide glue that gelled up too fast to get a nice tight glue line. :-)
>I've been a good boy and been taking my Lithium. You been taking your Prozac?
All kidding aside, if you remember the posts regarding the mysteries about nibs I've often called them sights to help anyone saw better. It�s always been a joke on my part. So, sorry if I pissed up off.
Lord knows I wish nibs would help anyone saw straighter.