Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

planing dovetails

Posts

planing dovetails

#1

planing dovetails

les winter

>In the discusion just below, the subject of planing dovetails contained an interesting point: gaps get covered up when the planing is done. I'd be interested in knowing if anyone has written about this. Only this weekend I was about to trash a drawer where the half-lap front turned out sloppy. I plained the thing anyway and got a surprise: the gaps largely closed up. Looked like magic.

Les

Re: planing dovetails

#2

Like rolling miters...

Stephen Shepherd in the State of Deseret

>some things just don't get written down.

Stephen

Re: planing dovetails

#3

speaking of rolling miters...

johnjesseph

>...any advice about rolling miters would be appreciated. I am always concerned that they may open up again after a while...

Re: planing dovetails

#4

Re: speaking of rolling miters...

Stephen Shepherd in the State of Deseret

>John,

I put a little glue along the open miter then roll it and allow the glue to dry. With the finish it is usually fine. I have seen some old pieces (150 years+) that I am sure had rolled miters and they were still tight. Examination on tne ends showed the grain was bent on both sides.

But I live in a very dry enviornment so that may make a difference.

Stephen