Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

looking for 3" carbide blade

Posts

looking for 3" carbide blade

#1

looking for 3" carbide blade

WarrenC

>I'm looking for a 3" carbide saw blade. I've seen a 4" and 2" you can get for a biscuit joiner. Does anyone know where I can look.

thanks

Warren

Re: looking for 3" carbide blade

#2

Re: looking for 3" carbide blade

Bill Tindall, E.TN

>Try Misenheimer 423 587 4300. I have had them make custom blades in the past and they were not a kings ransom.

Re: looking for 3" carbide blade

#3

How about a slitting saw? *LINK*

Phil Joines Krum, Tx

>MSC carries slitting saw blades in a bunch of diameters, arbor holes and thicknesses. Hold your skirt up for the solid carbide but the HSS are about 1/20 of the price of the carbide.


http://www1.mscdirect.com/CGI/N2DRVSH?PACACHE=000000052583460

Re: looking for 3" carbide blade

#4

MSC, Enco, McMaster-Carr, etc...

Alan DuBoff

>You can get slitting saws from most of these places. The HSS are quite a bit less, and a better value, IMO.

For some reason when the sizes of blades get over 3" in diameter they start to go up, and 2 3/4" can sometimes be gotten for much less.

Cost will depend on the size of the blade, I use mostly .018", .020", .025", and .032". Enco doesn't carry much, and MSC has the size I use, but McMaster-Carr also carries some.