Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Success with #81 Scraper

Posts

Success with #81 Scraper

#1

Success with #81 Scraper

Roy Anderson

>I found this old Stanley #81 scraper, alone and abandoned, in the barn of my wife's ancestral farm. It's been sitting in my basement for over a decade and I've never used it.

Last night I was having some trouble smoothing some Mahogany with multiple reversing grain, so I pulled it out and gave it a try. It didn't come with a blade so I had to get my modern scraper blade, turn it up endways and draw a burr on it. This only took a few minutes and it worked!

You can see the nice fluffy shavings it produced. The only downside is the holder system is a little fussy to get adjusted right, but no big deal. I'm pretty stoked!


img

Re: Success with #81 Scraper

#2

If you want to see more *LINK*

Roy Anderson

>If you want to see more about the #81 scraper and the on-going saga of my attempts to make a set of nesting tables, you are welcome to visit my blog. See link below.


My Woodworking Blog

Re: Success with #81 Scraper

#3

Re: Success with #81 Scraper

Glenn Madsen, SF Bay Area

>My dear wife bought me the modern version of that for Christmas a season or three back. It's never been out of the box since then, but that's more laziness and plywood projects than anything else. I guess I'll have to give it a try, since it seems to be such an easy deal. The hand (card) scrapers work well on maple for me.

Re: Success with #81 Scraper

#4

Good for you!

Scott Burr in Ben Lomond CA

>I've found them to be a bit fussy also. I found it tends to chatter a bit because of the distance between the blade clamp and the bottom of the wooden base.

I made sure the bottom and top surfaces of base were flat and parallel to each other. Then place a piece of regular ol' paper under the front of the scraper drop the blade down so it lightly rests on the work bench (or other flat surface) then tighten it down. Seems to work well to get it adjusted.