Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

evapo-rust

Posts

evapo-rust

#1

evapo-rust

john lucas

>I don't visit the handtools side very often so you might have covered this topic but it's new to me. I was restoring a wooden hand plane and the blades were really rust. Normally I use either Naval Jelly or reverse plating techniques to get rid of rust. I attacked these with Naval Jelly with multiple applications and really wasn't getting very far.

On a recent trip I stopped by a discount tool supply store near Gatlinburg Tn. and picked up a bottle of Evapo-rust. This is great stuff. Below is a photo after 24 hours of soaking. No rust at all and it took about 30 seconds to knock off the residue that was left. Even the bottom of the screw slot was clean. Water clean up. Easiest method I've ever tried for rust removeal. You can get to them at www.evapo-rust.com It was about $8 for the bottle but you only need enough chemical to cover the parts.


img

Re: evapo-rust

#2

Re: evapo-rust

Chicago Bob

>John,

I have also had good success with this material. A more inexpensive approach with the same results is to make a solution of citric acid in water (actually, evapo-rust is an aqueous solution of citric acid).

You can goggle citric acid and rust removal and get detailed procedural information. This is a much cheaper route as this acid salt can be purchased inexpensively on ebay.

If you need recommended concentration, let me know.

Re: evapo-rust

#3

Re: evapo-rust

Marv....... Northern California Lake Co.

>Hi John,

I have used this stuff for removing rust from badly rusted handsaws. It's been awhile, couple years since I used it. I was paying around $25.00 per gallon at the time. It does in fact do a good job of removing rust but the down side is, it wears out and stops working. I could only get about 3 saws derusted per gallon. For my purposes, it was just too expensive. I still have some in the shop, but I only use it on smaller items.

How much did you get for only $8.00?

Marv

Re: evapo-rust

#4

Re: evapo-rust

Todd O. Cronkhite Maine Native, Presently Away

>I've had very good luck using vinegar to derust smaller tools after a 24 hour soak. It's cheaper, and it beats having another chemical around the place. It also "wears out" but I got multiple uses out of it before it did. Give it a try, certainly worth a shot. Never tried it on saws.

T.O.