Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Domestic, Figured & Live Edge Hardwoods in Stock. Best Prices for Serious Woodworkers.

Looking for some Brace information *LINK*

Posts

Looking for some Brace information *LINK*

#1

Looking for some Brace information *LINK*

Doug Littlejohn

>I have a 'Spofford' type brace with the wooden handle and Knob. The handle is the 2 piece with Pewter rings type.

The metal has a fair amount of pitting but I can make out the following -

On one side is _

"John" space for 1-2 letters maybe, then "s" some more spacing maybe 4-6 letters and then "& Co"

On the other side is -

"No 10a"

I am thinking it might be a John S Fray & Co but cannot find a listing of what he made, model numbers, when, etc.

I can post a photo (need to take one) tonight if that would help but it looks just like one shown on

Snyassloot's website, 3rd brace down (link down below).

Any ideas where to find out more information ??

Thanks


Snyassloot webpage

Re: Looking for some Brace information *LINK*

#2

You realy don't need much more...

Scott Burr in Ben Lomond, CA

>You've dug quite well Doug (He he he...sorry couldn't help myself)

You have a John Fray, Spotford/ Pig patent brace. I can't explain every patent but, I believe the chuck was a Soptford/ Pig(g) Patent. The John

S. Fray & Co. produced the brace it's self. Their numbered in the 100's. A 104=a 4" sweep a 105=a 5" sweep...etc.

Their very nice braces IMHO. I'm currently on the hunt for the lager sweeps myself.

Re: Looking for some Brace information *LINK*

#3

Re: Looking for some Brace information

Stephen Shepherd in the State of Deseret

>Thanks for the link to that site, found my brace there.

Mine is a Fray & Pigg, Spafford Pattern (Patent) #7, but it has an unusual chuck. It is also one of the reasons it is my favorite summertime brace. (Because it is all metal I don't use it in the winter time).

I am not sure if this was added later or was part of the original. The pic on the other site doesn't look like it has this feature. The chuck has a small groove which will hold small bits and works quite well.

Stephen


img

Re: Looking for some Brace information *LINK*

#4

Re: Looking for some Brace information

Marv....... Northern California Lake Co.

>Stephen,

That's an interesting feature on your chuck. I have an all metal #10 like the one you have but it doesn't have the smaller "V",s. I'm wondering if perhaps someone filed them in using a taper file. I would guess that when you use a drill in that part of the chuck, it would not line up on center with the top handle and would wobble.

Marv

Re: Looking for some Brace information *LINK*

#5

Re: Looking for some Brace information

Stephen Shepherd in the State of Deseret

>Marv,

I can't tell if it is original or added later, it only goes up to about where the screw goes through the chuck. I have tried it and it is so little off center that it really doesn't wobble that I can see.

Because of the design of the Spafford chuck I am not sure you could spread it far enough apart to make that groove, after it was manufacturered. I will spread it open a bit tomorrow to see if I can see any more detail, but I will not put the brace in danger of breaking.

Stephen