Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

need help with hot glue question

Posts

need help with hot glue question

#1

need help with hot glue question

McKay Sleight

>I cooked up a fresh batch of hot hide glue to help a student veneer some quarter sawn red oak onto mdf. The glue acted fine and I rubbed two pieces together to make sure there was a bond. However, when we applied the glue and hammered it down, the seam between the two pieces of QSRO buckled. I was really surprised that any buckling occurred. What say you? Thanks in advance.

Re: need help with hot glue question

#2

Re: need help with hot glue question

ThomD

>Should be OK if you used veneer tape. I wouldn't do it over MDF, but I can't say that would be a cause of the problem. With hide glue, nothing is final, just heat with iron and "hammer" it down. Also I sometime put one side down and then nudge the other into it when the first has cooled.

Re: need help with hot glue question

#3

Re: need help with hot glue question

Stephen Shepherd in the State of Deseret

>The moisture from the hot hide glue may have caused the veneer to expand, did you moisten the top of the QSRO?

How big is the finished piece? If it is too big to heat up and re-adjust you can do some surgery at the joint.

Heat up the joint and get one layer of veneer on top of the other and than let it cool. With a straight edge and sharp knife, cut down through both layers of veneer along the joint. Heat up the joint again and remove the waste overlap strips and smooth down the joint.

Stephen