Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Mild gloat

Posts

Mild gloat

#1

Mild gloat

Bill Houghton, Sebastopol, CA

>I mentioned t'other day that I now own a LV small router plane. This and the Veritas pullshave were recent acquisitions to keep my tool jones quiet (all of which is sublimation for the fact that I haven't been getting shop time since I went back in harness with my old employer to earn $$ for our bathroom remodels, landscaping, etc.). Haven't even had the chance to play with them, but my they're pretty.


img

Re: Mild gloat

#2

Re: Mild gloat

Chuck Nickerson

>The pullshave is very nice for seat carving. I've almost finished the jig for a repeatable sharpening method.

Re: Mild gloat

#3

They will serve you well...

Scott Burr in Ben Lomond CA

>Hope you get to play with them soon. It's been over a year sence I received my pull shave, and I havn't got to use it yet. At least dinning room shars are on the todo list, slowly inching the way to the top.

Oh yea, You get a mild "you suck"!

Re: Mild gloat

#5

Re: Mild gloat

Paul M.

>I got to use a LV pull shave once when making a chair seat last year. I wasn't overly impressed. I prefer the control of a travisher to be able to "flick" my wrists to get to the area I want to remove. I found the pull shave to be a cumbersome replacement. I had access to both, so I tried using the pull shave first, but switched to the travisher.

This was not just a matter of familiarity with one tool over the other. This is probably my 3rd or 4th total chair seat, and I only do one a year as part of the volunteer staff of the San Diego Fine Woodworker clubs chair-making booth at the Del Mar Fair. So I'm not terribly familiar with either tool. But I have an entry-level preference for a travisher instead.