Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

Source for brass "rivets"? *LINK*

Posts

Source for brass "rivets"? *LINK*

#1

Source for brass "rivets"? *LINK*

Dave Mount

>Maybe rivets isn't the right term.

Suppose a guy made a float and wanted to put wood scales on as a handle and wanted to attach them with brass rivets/pins/fasteners as it is often done. What are those brass fasteners and where do you get them? Are they the "Chicago bolts" Lee Valley sells (link below)?

Maybe I should ask the question more generally -- if you want to attach wood scales to both sides of flat steel bar, how do you do it (with some class)?

Thanks,

Dave


Lee Valley Chicago bolts

Re: Source for brass "rivets"? *LINK*

#3

Re: Thanks!

Dave Mount

>

Re: Source for brass "rivets"? *LINK*

#4

Re: Source for brass "rivets"?

Moses Yoder in White Pigeon, MI

>Knife makers etc. I think normally just use a round brass rod. When I make knives I drill holes in the steel blank (spaced to look good) either 1/8" or 3/16" or whatever will match the brass rod diameter. Then I cut the wood scales and clamp one side to the steel and drill the holes through, then clamp the other side and drill the holes through (make sure the ends match up). I then cut a couple pieces of brass rod to length (oversized by 1/8" or so). I mix an epoxy and glue the wood to the steel with the brass rods through the holes holding the wood in place. The next day after the glue is dry I take the clamps off and peen the brass rod on my $7 per pound 9 pound anvil. You peen carefully so the brass fills the hole tightly but does not split the wood. The wood is oversized wheverever it can be and is then rasped/filed/sanded to flush agains the steel after the brass is peened.

Re: Source for brass "rivets"? *LINK*

#5

Exactly how Moses said.

David Barnett - SW Florida

>I find this the easiest, surest, most flexible and aesthetic way to pin scales on knives, handtools, flatware, raised vessels and cookware. It's a simple and satisfying process. You can make the pins any diameter (I like smallish) and almost any metal. Besides brass, there's nickel(18%), stainless steel and sterling silver, too. No screw slots, no too-large cheesy rivet heads.

Re: Source for brass "rivets"? *LINK*

#6

Corby Fasteners

CJ McLaughlin

>These seem to be the easiest in that you get a secure connection without need for glue (though I would use glue).

Rod is the cheapest and if you use glue, the rod helps with alignment.

CJ