Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

? on tuning a side bead iron

Posts

? on tuning a side bead iron

#1

? on tuning a side bead iron

Dave Mount

>I made a 1/4" side bead plane (pics will come in good time) and I'm working on getting it cutting well. I've never even handled a vintage side bead so I'm working from pictures found on the net and don't have a working model to learn from. I've opened the mouth roughly 1/32". In use, it clears the main shaving from the quirk as it starts to sink, but I get a buildup of fine, fibrous material over the deepest part of the profile (these test cuts are in paper birch, which I find easy to plane in general, with the exception of frequent grain reversals). When the plane sinks deep enough that the bead part of the profile should start cutting, I find that the fibrous material deposited earlier in the process just kind of mats over the rounded part of the profile and it won't cut. I have to remove the iron to clear the material, reset the iron, then it cuts OK, but it's a pain. Any suggestions? How wide should the mouth be? I can easily float it open a little more, but I'm hesitant to open the mouth more if the problem might be elsewhere. How critical is the mouth opening on a small bead like this?

Thanks for any advice,

Dave

Re: ? on tuning a side bead iron

#2

hb

Re: ? on tuning a side bead iron

HB

>I have a couple of these and for the most part, the mouths are pretty wide open. Like about an 1/8 inch on my quarter inch bead. I do have tearout at grain reversal, but I always attributed that to a less than ideally sharp blade. never occured to me tht maybe the mouth was too wide.

I do know that when the bead part of the iron starts to take a full shave, it's pretty thick because of its shape.

Although I know its supposed to leave a good surface - remember -it's not a smoothing plane so the larger mouth should be the way to go. Really, all the work in moulding is in picking the right stock to start with, rather than using a plane set up to handle tough grain.

HB