Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

Quick help needed...

Posts

Quick help needed...

#1

Quick help needed...

Ted Owen, Pittsburgh

>Our turning club has decided to run a series of newsletter articles on four important power tools for the turning shop--lathe, grinder, bandsaw, chainsaw. Since I'm a bandsaw nut, I've been asked to write the full-page article, or series of articles if I prefer, on the bandsaw as it relates to turning. And I have to turn it in to the newsletter editor by tonight or tomorrow morning.

I've prepared a quick outline as follows:

size--wheels, resaw, table, weight

new vs. used and pricing

features such as tilt table

blades--skip-tooth, 3tpi, bimetal (carbide only if no nails)

guides--not as important in my view as most people believe

support for uneven and unbalanced stock

wedges to keep kerf open on green stock

cutting order--face and bottom flats, true up ends, then curve cuts

Any quick suggestions on what I'm missing, or what should be fleshed out, would be helpful and appreciated. Sorry for the short notice on my request, but it was equally short for me, too.

Thanks,

Ted

Re: Quick help needed...

#2

Re: Quick help needed...

Bob Hackett

>How about sawing the half log using the disc tacked to the curved side trick.

The importance of rounding the back of the blade when cutting small circles or tight curves.

cleaning,drying and waxing the saw after cutting green wood.

Stance at the saw and pulling the stock thru(hands behind the blade) as opposed to pushing.

That`s about it from me.

Mainely,Bob

Re: Quick help needed...

#3

Re: Quick help needed...

ThomD

>Maybe safety, like brakes kill, switches, unlimited geometry. How to anticipate the draw down on the workpiece when sawing unsupported, how the depth of cut can even out for lack of stability. Danger and motor size.

Re: Quick help needed...

#4

Re: Quick help needed...

"RJ" Whelan

>Tires and tracking ... rj

Re: Quick help needed...

#6

Re: Quick help needed...

Bruce, a MN Galoot

>fences

drift

placement of hands

outfeed support

Re: Quick help needed...

#7

Thanks, everyone...

Ted Owen, Pittsburgh

>I've got these ideas into the article, and it's much better than if I had done it alone.

Best, Ted