Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Tool Refinishing

Posts

Tool Refinishing

#1

Tool Refinishing

David Miller from Iowa

>Picked up a decent Stanley #66 hand beader Type 1 - painted bright green.

I'm not going to re-jappan it, so what is the next best choice - spray enamel?

Thanks

Re: Tool Refinishing

#2

Re: Tool Refinishing

Todd Hughes

>I had a friend get one befor that was painted blue. He used a mild paint stripper on it and carefully removed to blue paint to find that underneath it was about 90% of the original jappaning...somthing to try.

...If you want to paint it imagine spray paint would work ...Maybe what the guy used when he painted it green .....Todd

Re: Tool Refinishing

#3

Jack Guzman from Maine

Re: Tool Refinishing

Jack Guzman from Maine

>Why not leave it green? I don't think you'll mind so much when you're using it.If the color really offends you,just strip it and coat it with a light coat of oil.If you gotta have a color,rustoleum works fine.---Jack

Re: Tool Refinishing

#4

Kunz or John Deere green?

Scott Burr in Ben Lomond CA

>Marv might want to buy it from you;^).

My favorite choice here is black epoxy paint brushed or sprayed.

Re: Tool Refinishing

#5

Re: Tool Refinishing

Derek Cohen (in Perth, Australia)

>Hi David

I sometimes find really rusty tools. After citric acid, they end up bare cast iron. What I may do is use a deburring wheel on the metal, remove the tarnish, and what is left is a clean surface. I then wax it for protection.

Here is a #66 I have:



Of course you may want to try my fence modification (article in archives). Makes a world of difference..



The other plane I have just done like this is a #46. This is in good condition - actually very good condition - but started out very rusty. Now I am even thinking about re-nickeling. It is just a user, but may be worth the effort because it is such a nice plane (and it came with all the blades). What do the others here think?





Regards from Perth

Derek

Re: Tool Refinishing

#6

Thanks

David Miller from Iowa

>to all the posters.

Derek - I think I will make a fence as you suggest. I'll probably just use the original fence as the starter, should be pretty easy.

Re: Tool Refinishing

#7

Re: Tool Refinishing

Mike Hamilton

>Derek,

Two questions:

How did you handle the pinned handle and citric acid bath?

Can you explain a 'deburring' wheel?

Regards,

Mike Hamilton

Plainfield, IN

Re: Tool Refinishing

#8

Re: Tool Refinishing

Derek Cohen (in Perth, Australia)

>Hi Mike

A deburring wheel is used ... to deburr ... remove burrs after grinding. They come in different grits and are capable of polishing steel to a mirror.

Here is one (picture taken off eBay):



The handle on the #46 was taped up tightly with waterproof tape. I did not want to damage the wood by forcing out the pins.

Regards from Perth

Derek