I can give you no help on this one...
Stephen Shepherd in the State of Deseret
>I am a big fan of laminated blades on any tool. I think the tapered plane blades are great and all mine are with chip breakers (yes I said it) so they are double irons.
And this is where it gets difficult. I own a small (block plane size) beech coffin smoother made in England (from a box of English tools), with no makers marks on plane or iron. It is a factory made item and has a single iron. It is parallel, I have examined it and I can not see lamination, but I haven't given it the acid test to make sure.
I think the test will show that it is an all steel iron. It is the one of the finest wooden smoother planes I have ever used, not a real tight mouth but it sure does cut nice. I had to work over the bed and wedge ways, wedge and iron but mostly to remove rust and surface accumulations.
As for over tightening, I can't say, I think the wedge and blade may come out easier than the tapered double iron but that may be its size.
Also I make my toothing irons out of parallel blades, and for use in old planes I have to shim the bed to hold the iron because it is much thinner. Otherwise the tips of the wedge protrude below the sole of the plane, interfering with the planing process.
Stephen