Re: Uses of edge-trimming block plane
Derek Cohen (in Perth, Australia)
>Hi Bill
It is easier to explain by first saying what these planes are not ..
They are not a substitute for a jointer as they are too short to ensure a flat edge. The edge block plane is designed to create a square edge.
Further, it is not a plane I turn to when the boards are wide enough for a jointer, or short enough to fit on a shooting board.
However, when boards are thin (< 3/8"), where it is difficult to balance a wide plane, or the sides are too long for the shooting board, then it is a very useful plane. I use these surprisingly quite often when making boxes.
I used the following example a little while ago on WoodNet, where the same question was raised. I apologise to those who have seen it before..
My workshop, along with most of my tools, was packed up for an addition to home. This included the edge planes. I could have used them as I worked to smooth and level the rims of a box I was making. It had been cut open and the picture below was taken as I worked on it with the longest plane I had to hand. An edge plane would have been a natural for this task.
You can get along very well without one of these planes. You could instead just use an ordinary block plane. But they will get frequent use if you do have one (or two) in your arsenal.
Regards from Perth
Derek