Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Plane Repair Question

Posts

Plane Repair Question

#1

Plane Repair Question

Tom MacGregor

>I want to repair a plane with a bent threaded rod for the adjuster knob. I have a spare frog that doesn't fit, but with a good rod. Any ideas on out how to remove it without damaging the threads? It would be a lot easier if Vaughan & Bushnell hadn't used a left-hand OEM thread on this #4 size Uncle Sam series smoother (poorly concealed gloat).

Re: Plane Repair Question

#2

Re: Plane Repair Question

mvflaim

>You can try wrapping pieces of cork around the jaws of a pair of vise grips. That should give you the strength you need to turn the thread out without damaging the threads too bad.

Re: Plane Repair Question

#3

Re: Plane Repair Question

Bob Hackett

>Wrap some copper(like a strip cut from a water pipe)around the thread and then grab with a pair of vicegrips.Adjust the vicegrips to grab hard enough so there is no slip when you turn the whole mess.

Copper will shield the threads by conforming to thier profile and unlike other things(tape comes to mind)both hang together and give you the traction you need to remove the part.

Hey,don`t thank me,it`s an old outside machinist`s trick.

Mainely,Bob

Re: Plane Repair Question

#4

Re: great trick

David Charlesworth

>Bob,

What a great trick, thank you.

David

Re: Plane Repair Question

#5

It worked, Thanks!

Tom MacGregor

>

Re: Plane Repair Question

#6

Re: Plane Repair Question

paul womack

>With this object, I use a variation; you can actually get enough access (with the frog removed) to get the adjuster bolt in to a (jaws softened with Al or Cu as Bob said) vise; since the vise is fixed to the bench, removing the rod is done by simply turning the frog; half a turn is normally enough to free the thread, which can then be run out with your fingers.

I prefer a "real" vise to vise grips (or mole grips as we say in the UK), since the gripping surface is larger, and the vise is fixed down.

But, as I say, it's just a variation.

BugBear